ITW Buildex Backer On

Backer-On™ Fastener

Backer-on fasteners are specifically designed and recognized for use with HardieBacker^® cement backerboard. The high-performance gimlet point makes for easy installation with no pre-drilling required. Climacoat™ finish resists corrosion which can lead to unsightly rust bleeding into tile.

BACKER ON

FEATURES

Recognized for use with HardieBacker cement board.
Installs easily – no pre-drilling required.
Rib design under head countersinks into dense material while preventing strip-outs.
#2 square drive prevents bit from slipping.

MODELS
INSTALLATION STEPS
DOWNLOAD

BACKER ON FASTENER
PART NO.	DESCRIPTION
2406000	10 x 1-1/4”

STEP 1:
A standard screw gun with a depth sensitive nosepiece should be used to install Teks. For optimal fastener performance, the screw gun should be a minimum of 4 amps and have an RPM range of 0-2500.

STEP 2:
Adjust the screw gun nosepiece to properly seat the fastener.

STEP 3:
New magnetic sockets must be correctly set before use. Remove chip build-up as needed.

STEP 4:
Overdriving may result in torsional failure of the fastener or strip out of the substrate.

STEP 5:
The fastener must penetrate beyond the metal structure a minimum of 3 pitches of thread.


2010-2011 BUILDEX CATALOG	BACKER ON DATASHEET