ITW Buildex Teks Architectural Clip Fasteners

Teks^® Architectural Clip Fastener

Teks self-drilling fasteners for attaching low profile architectural metal roof clips to steel purlins or wood supports.

tekslowprofile

FEATURES

#12 diameter utilizes the ITW exclusive Phillips
Square-Driv with patented interlocking
components.
#10 diameter uses the coated Phillips drive
system providing improved driver bit to fastener
stability and friction fit.
Teks 3 fasteners are available with Gray Spex™
coating; Type A fasteners with Climacoat®.

MODELS
INSTALLATION STEPS
APPLICATIONS
DOWNLOAD

TEKS ARCHITECTURAL CLIP FASTNER
PART NO.	DESCRIPTION	HEAD STYLE	DRILL POINT
1560553	10-16 X 1 "	#2 Phillips Pancake	3
1575553	12-14 X 1"	#2 PSD Pancake	3
1713053	1/4-14 x 1 1/4"	HWH 5/16” AF	3
1596553	10-12 X 1"	#2 Phillips Pancake	Type A
1640553	10-12 X 1-1/2"	#2 Phillips Pancake	Type A
1597553	12-11 X 1"	#2 PSD Pancake	Type A
Installation Tools
1588910	#2 PSD BIT
2128910	#2 BIT

STEP 1:
A standard screw gun with a depth sensitive nosepiece should be used to install Teks. For optimal fastener performance, the screw gun should be a minimum of 4 amps and have an RPM range of 0-2500.

STEP 2:
Adjust the screw gun nosepiece to properly seat the fastener.

STEP 3:
New magnetic sockets must be correctly set before use. Remove chip build-up as needed.

STEP 4:
The fastener is fully seated when the head is flush with the work surface.

STEP 5:
Overdriving may result in torsional failure of the fastener or strip out of the substrate.

STEP 6:
The fastener must penetrate beyond the metal structure a minimum of 3 pitches of thread.


2010-2011 BUILDEX CATALOG	TEKS ARCHITECTURAL CLIP FASTENERS DATASHEET	TEKS ARCHITECTURAL CLIP FASTENERS TECHNICAL DRAWINGS