Stitch fastener for insulated panels, stitch roof and wall non-insulated panel sidelaps, and trim applications.
Low Profile Design features a "button" head for improved building aesthetics.
Maxiseal® Integrated Washer Design extends the washer life and improves washer contact with material being fastened.
Anti-Backout (ABOT™) Threadform resists and minimizes backout of fasteners while maintaining the integrity of connection during material expansion and contraction.
Teks 1 Drill Point drills and taps into steel from .018" to .095" without pre-drilling.
P3 Powder Coating has a chalk and fade performance equivalent to 70% fluoropolymer coated metal panels.
TEKS SELECT FASTENER
1/4-14 x 7/8"
Maxiseal Low Profile Pan
.018" - .095"
STEP 1: A standard screw gun with a depth sensitive nosepiece should be used to install Teks. For optimal fastener performance, the screw gun should be a minimum of 4 amps and have an RPM range of 0-2500.
STEP 2: Adjust the screw gun nosepiece to properly seat the fastener.
STEP 3: New magnetic sockets must be correctly set before use. Remove chip build-up as needed.
STEP 4: The fastener is fully seated when the head is flush with the work surface.
STEP 5: Overdriving may result in torsional failure of the fastener or strip out of the substrate.
STEP 6: The fastener must penetrate beyond the metal structure a minimum of 3 pitches of thread.
Teks Low Profile fasteners are specifically designed to be aesthetically pleaseing eliminating the "battleship" look of buildings.
- Stitch Fastener for Insulated Panels -
- Stitch Roof and Wall Non-Insulated Panel Sidelaps -
- Trim Applications -