Home | Up | Horizontal | Vertical | Performance Data

HORIZONTAL

 

Important Horizontal Installation Notes
Model 14SW
Nut Driver
Item 101

PN  8114910
bulletWarranty requires the use of appropriate nut driver for installations.
bulletSidewinders must be installed using Model #14SW (Red) nut driver only.
Eye protection should be worn at all times when installing this product

 

Horizontal Installation for Steel or Wood
SWD • SWDR • SWT • SWG
bulletSWD - Drills & taps through 3/16" metal
bulletSWDR - Drills & taps through 3/16" metal, accepts retainer nut
bulletSWT - Drills & taps through ½" metal
bulletSWG - Drills & taps into wooden structures.
  1. Insert the #14 SW nut driver in the drill unit (Fig 11).
  2. Insert the screw into the nut driver (Fig 12).
  3. With drill unit in a horizontal position and at a right angle to the structural member begin installation (Fig 13). When the nut driver spins free on the screw, stop and remove the drill.

The unit is now ready to receive ¼", ⅜" or metric all thread rod or bolt stock (Fig 14). Be sure rod is threaded completely through unit head. for maximum pullout in purlin steel.
Note for SWDR: When installing SWDR follow the above instructions, then add retainer nut and torque to 20 foot lbs.

 

Horizontal Installation for Concrete
SWC
Self tapping into concrete • Use a 1200 maximum RPM drill for installation
  1. Using a SDS 250 carbide tip bit or a HEX RECEIVER with a #250 carbide tip bit, predrill the concrete member to a depth of 2" with an impact/drill set on impact mode (Figs 15 & 16).
  2. After pre-drilling has been completed, with the bit still in the drill, install the SLEEVE TOOL over the bit (Fig 17).
  3. Insert the #14SW nut driver into the opposite end. Install the SWC screw into the nut driver (Fig 18). You are now ready to install the screw into the concrete member.
  4. Place tip of screw into the pre-drilled hole (Fig 19), turn impact/drill unit to drill mode and begin insertion. When the nut driver spins free on the SWC screw, installation is complete. Stop and remove drill.
  5. The SWC screw is ready to receive ¼", ⅜", ½", or metric all thread rod or bolt stock.
Note: Do not install concrete screws while the drill unit is in impact mode — doing so will destroy the pullout factor of the fastener.

 

Home | Horizontal | Vertical | Performance Data

Information: submit a request or contact, marketing@itwbuildex.com

Last modified: April 28, 2009         -   An independent, non-profit content rating organization.
Copyright © 2002-2009:   ITW Buildex. All trademarks or registered trademarks used are trademarks of Sammy Super Screw®, ITW Buildex and Illinois Tool Works, Inc.   ITW Buildex Privacy PolicyITW Buildex uses WebTrends Live to analyze traffic to this web site.  WebTrends Live does not create individual profiles for visitors.  Unlike some tracking services WebTrends Live does not have a database of individual profiles for each visitor.  WebTrends Live only collects aggregate data.  For more information about WebTrends Live privacy policy, please click here.

Send mail to: webmaster@itwbuildex.com  with questions or comments about the webpage.